To get rid of mould on walls, fix the moisture that feeds it, kill the mould with a fungicidal wash, let the wall dry, seal the stain with a stain-block primer and finish with anti-mould emulsion. Skip the first step and the black spots will be back through your new paint by February.

Most of the mould we see in Dublin homes is condensation mould: black speckling in bedroom corners, round window reveals and on bathroom ceilings. It turns up from October, once the windows stay shut and the heating goes on.

Condensation, rising damp or a leak: which do you have?

Condensation forms when warm, moist air meets a cold surface. Signs:

  • black spots in the top corners of rooms and along the ceiling line of outside walls
  • water beading on the window glass first thing in the morning
  • mould behind wardrobes, beds and sofas pushed against an outside wall
  • a problem that gets worse in winter and fades in summer

Rising damp comes up from the ground through a failed or bridged damp-proof course. It stays low: a tide mark up to about a metre above the skirting, sometimes with white salts, crumbling plaster and blistered paint. It affects ground floors only, in every season. Plenty of “rising damp” turns out to be condensation, or a flower bed banked up against the outside wall.

A leak gives you one patch, often with a brown or yellow ring, under a bathroom, beside a downpipe or round a chimney breast. It tends to spread after heavy rain.

You can have more than one. A wall soaked by an overflowing gutter stays colder, and condensation mould follows.

Fix the cause first

Anti-mould emulsion slows regrowth on the paint surface, but a room that makes more moisture than it lets out will grow mould on it anyway. For condensation in a typical Irish house, the fixes come down to habits:

  • Dry clothes outside or in a dryer. A load of wet washing on the radiators puts litres of water into the air, and it settles on your coldest wall. A vented dryer needs its hose out through a window or wall vent.
  • Open the trickle vents on your windows and leave them open through the winter. Plenty of people close them to stop draughts.
  • Run the extractor fans. Keep the bathroom fan on during the shower and for 15 to 20 minutes after, with the door shut. If a fan can’t hold a sheet of toilet paper against the grille, clean or replace it. Use the cooker hood and put lids on pots.
  • Keep cold rooms at a low, steady heat instead of short blasts. A spare room that drops to 10 degrees gives the moisture a cold wall to land on.
  • Air the bedroom in the morning. Open the window for ten minutes after you get up.
  • Pull furniture a few centimetres off outside walls so air can move behind it.

A cheap hygrometer shows the humidity in each room. Above about 60% for long stretches in winter, expect mould.

Kill the mould safely

Protect yourself. Wear rubber gloves, eye protection and a well-fitting FFP2 mask, open the window and keep children and pets out of the room. If anyone in the house has asthma, allergies or a breathing condition, or the mould covers a large area, get professional help instead of doing it yourself.

Wet it before you touch it. Dry-brushing mould sends spores into the air.

Use a fungicidal mould wash, not bleach. Bleach lightens the stain so the wall looks clean, but on porous plaster and paint it won’t reliably kill the growth below the surface. It’s mostly water, too, so you’re wetting a wall you need dry. Decorating suppliers sell fungicidal washes made for the job. Apply with a sponge or brush, leave it for the time on the label, and rinse only if the label says so.

Bin the cloths. Bag used sponges and cloths, throw them out and wash your clothes.

With the wall clean, look at the paint. Scrape anything flaking, bubbled or soft back to a sound edge and fill. Black silicone round a bath or shower is usually stained right through, so cut it out and reseal.

Let the wall dry

Give it at least a day or two in a heated, aired room, and longer on an outside wall in winter. Plaster that still feels cold and damp to the back of your hand isn’t ready. Painting damp walls traps the moisture under the new coat, and you get blistering and fresh mould.

Stain-block, then anti-mould emulsion

Dead mould leaves a grey shadow, and emulsion straight on top shows it again within days. A stain-block primer seals that mark in. Spot-prime the treated patches, or prime the whole wall if the staining is widespread.

Then apply two coats of anti-mould emulsion. The main ranges, including Dulux, Colourtrend and Fleetwood, make bathroom and kitchen paints that combine a fungicide with a tougher, wipeable film. For a bedroom with a history of mould, use the bathroom-grade paint on the outside walls and ceiling. Use it for both coats: an ordinary topcoat over an anti-mould first coat leaves plain emulsion on the surface, where mould grows.

Our interior painting service covers all of this: we wash down and treat the affected areas, let them dry, stain-block, and finish in anti-mould emulsion by brush and roller.

Rooms where mould comes back every winter

  • Bathrooms, especially ones with no window, or a fan someone switched off at the isolator because of the noise. The ceiling above the shower goes first.
  • North-facing bedrooms. The outside wall never gets sun, so the inside face stays cold. Add a closed door and two people asleep and you get mould in the corners and behind the headboard.
  • Behind wardrobes on an outside wall, where the air never moves.
  • Window reveals. The plaster round the frame is often the coldest surface in the room, and condensation running off the glass soaks the sill.
  • Stairwells and landings, where a big landing window collects moisture from the whole house. If the hall needs a repaint once the walls are treated, see our hall, stairs and landing painting page.

In these rooms the habits above matter more than the paint. Even after a good repaint, wipe the window reveals every week or two through the winter.

When to call a painter, and when to call someone else

A painter is the right call when the mould is surface condensation mould, the cause is under control and the plaster underneath is sound. That’s prep-and-paint work; see how long it takes to paint a room.

Call a different trade first if:

  • the damp sits low on a ground-floor wall with a tide mark or salts: a damp specialist or building surveyor
  • the patch is under a bathroom, near a water tank or along a pipe run: a plumber
  • it shows on a ceiling or chimney breast after rain, or next to a gutter: a roofer
  • the plaster is soft or coming away: a plasterer, once the cause is fixed

We’re painters, and we’ll tell you on the quote visit if something needs one of those trades before a brush goes near the wall. Paint over an active leak fails, and you end up paying for the same room twice.

Landlords: damp and mould also bring legal duties, covered in our guide to painting a rental property in Dublin.

Mould on walls: common questions

Can you paint over mould?

No. Live mould grows through a new coat, often within weeks. Kill it with a fungicidal wash, let the wall dry, seal the stain with a stain-block primer, then paint.

Does anti-mould paint work?

Yes, on a wall where you’ve dealt with the cause. The fungicide slows new growth, and a bathroom-grade finish stands up to regular wiping. In a room that’s wet with condensation every night, mould comes back on any paint.

How long after cleaning mould can I paint?

Wait until the wall is dry right through: at least a day or two in a heated, aired room, longer on a cold outside wall in winter. Check the label on your mould wash too, as some set a minimum time before you overcoat.

Is black mould on walls dangerous to my health?

Mould can irritate eyes, skin and airways, and it’s more of a concern for people with asthma, allergies or a weakened immune system. If anyone at home has health worries, speak to your GP and get professional help with the clean-up.

Get the walls treated and repainted

Check our Dublin painting prices for a rough idea of cost, then send us photos of the affected walls for a free, no-obligation quote.